Troubleshooting¶
The most common problems, and what you can do yourself.
The app does not find the box¶
- The phone must be on the same network as the box: not on 4G, not on a guest network.
- If the box does not appear under Found on this network, add it
by its address:
etm-powersync.localfor a box installed from the image, or the IP address your internet router gave it. That address can change: read it again in your router. - On a virtual machine, use a bridged network rather than NAT.
- If the connection is refused, check on the box that the service is running:
systemctl is-active nymeadmust answeractive.
More details: First connection.
"This box's certificate has changed"¶
The app remembered the fingerprint of the box's certificate at the first connection. If it changes, the app refuses the connection, and nothing is sent to the box.
- The box has been reinstalled (new card, new image): this is expected, it has a new certificate. In Installations, tap the box's key icon (Replace the certificate fingerprint), then Continue, unlock the phone, and compare the old and the new fingerprint before replacing it. Removing the box and adding it again is not enough.
- You don't know why: replace nothing. It may not be your box answering at that address.
Forgotten password¶
The accounts stay on the box, with no online service: there is no recovery by e-mail, and the app in this version does not reset a password. Ask your installer. Write down both accounts (administrator and user) as soon as they are created.
A device is not discovered¶
In Add a device, the search can take up to a minute and a half: the app says so and offers Cancel. Beyond that, it reports that the box did not answer in time (1 min 30 s).
If it answers that no device was found:
- is the device switched on and connected to the same network as the box?
- for an Eastron SDM meter on a Modbus RTU bus, first declare the serial adapter in Modbus RTU, then search again;
- check that the model is in the compatibility list. Some models cannot be added from the app, and the catalogue says so.
Adding asks for a setting¶
Some devices need information that discovery does not provide. The app asks for it before adding, and Add stays greyed out while it is missing. This is the case for the wiring of the V2C Trydan station: single-phase or three-phase, according to how it is connected. See the V2C Trydan page.
A load is still shown after removing a device¶
When you remove a device that an EMS load controls, the app offers to remove the device and its load together. If the device is removed but not the load, the app says so and offers EMS settings: remove the load there, in an administrator session.
If a removal is stopped because changes are pending in EMS settings, save or cancel them first: nothing has been removed.
A load does not start¶
Look at the line under the load: it says why the box made its decision (no surplus, below the first stage, battery reserve, waiting for off-peak hours, supply limit…). See Solar surplus and Load shedding. A station in Manuel (manual) follows its Charge switch: off, it stays stopped. A station allowed to charge whose car draws nothing: check the car (battery full, scheduled charging…).
Updating the box¶
On the box, in a terminal:
sudo apt install powersync-core on a box where it is already installed does not update it:
apt upgrade does. See APT repository.