Skip to content

Keba

TESTING ETM

Connection: LOCAL

Control wallboxes made by Keba.

Keba charging stations (P30 and P31 ranges), communicating over Modbus TCP on the local network.

1. Hardware required

  • A Keba P30 or P31 charging station
  • An Ethernet connection to the hub's network

2. Enabling Modbus TCP

Modbus TCP is disabled by default on Keba charging stations. Enable it from the station's web interface (port 502).

Modbus activation

Without this step the station will not answer PowerSync.

3. Adding in PowerSync

Added by automatic discovery on the network, or manually (IP address, port 502). See Adding a device.

4. Verification

connected, pluggedIn and then charging reflect the state of the session.


Reference

Application labels

The keys and labels below are the ones the application shows, in English. They are left verbatim so that you find them word for word on screen.

Manufacturer: Keba
Plugin: Keba

Supported models

Model Role Transport Pairing Quantities
Keba KeContact EV charger, Consumption meter UDP (KeContact) Auto-discovery / Manual 31
KeConnect German Edition EV charger UDP (KeContact) Auto-discovery / Manual 19

Per-model detail

Keba KeContact — keba

Settings:

Key Label Type Range Default Read-only
macAddress MAC address QString — — yes
hostName Host name QString — — no
address IP address QString — — no
serialNumber Serial number QString — — yes
model Product name QString — — yes

Measured quantities:

Key Quantity Type Unit
connected Connected bool —
power Charging enabled bool —
systemEnabled System enabled bool —
phaseCount Number of connected phases uint —
activity Activity QString —
plugState Plug state QString —
pluggedIn Car plugged in bool —
charging Charging bool —
maxChargingCurrent Maximal charging current double Ampere
maxChargingCurrentPercent Maximal charging current in percent uint Percentage
maxChargingCurrentHardware Maximal hardware charging current uint Ampere
voltagePhaseA Voltage phase A int Volt
voltagePhaseB Voltage phase B int Volt
voltagePhaseC Voltage phase C int Volt
currentPhaseA Current phase A double Ampere
currentPhaseB Current phase B double Ampere
currentPhaseC Current phase C double Ampere
currentPower Power consumption double Watt
powerFactor Power factor double Percentage
sessionId Session ID uint —
sessionTime Session time int Minutes
sessionEnergy Session energy double KiloWattHour
totalEnergyConsumed Total energy consumed double KiloWattHour
outputX2 Output X2 bool —
input Input bool —
uptime Uptime int Minutes
error1 Error 1 int —
error2 Error 2 int —
failsafeMode Failsafe mode bool —
firmware Firmware QString —
hostAddress Host address QString —
KeConnect German Edition — kebaSimple

Settings:

Key Label Type Range Default Read-only
macAddress MAC address QString — — yes
hostName Host name QString — — no
address IP address QString — — no
serialNumber Serial number QString — — yes
model Product name QString — — yes

Measured quantities:

Key Quantity Type Unit
connected Connected bool —
power Charging enabled bool —
systemEnabled System enabled bool —
phaseCount Number of connected phases uint —
activity Activity QString —
plugState Plug state QString —
pluggedIn Car plugged in bool —
charging Charging bool —
maxChargingCurrent Maximal charging current double Ampere
maxChargingCurrentPercent Maximal charging current in percent uint Percentage
maxChargingCurrentHardware Maximal hardware charging current uint Ampere
outputX2 Output X2 bool —
input Input bool —
uptime Uptime int Minutes
error1 Error 1 int —
error2 Error 2 int —
failsafeMode Failsafe mode bool —
firmware Firmware QString —
hostAddress Host address QString —